Low CostLow Viscosity – wets out well over any surfaceEvaporates QuicklyUltra Thin Film – does not interfere with reproduction of surface detail or finishGives cured rubber mold surface a smooth, satin finishRemovable – can be rinsed from model surface with warm waterInstructionsSafety – CONTENTS FLAMMABLE: Keep product away from flame and all ignition sources. Use in a properly ventilated area (“room size” ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.Store and use material at room temperature (73°F/23°C). This product has a limited shelf life and should be used as soon as possible.NOTE: ALWAYS SHAKE WELL BEFORE USINGA minimum of 2 coats of SuperSeal® is recommended to seal most surfaces. For extremely porous surfaces (i.e. limestone or dry plaster) an additional coat of SuperSeal® may be required. Or apply two coats of SuperSeal® and follow with an application of Ease Release® 200. Superseal® can be applied using a soft brush or a non-aerosol spray bottle to lightly mist SuperSeal® onto model.Apply a thorough thin coating of SuperSeal® over entire model surface and surrounding forms including intricate detail and undercuts. Compressed air or a hair dryer may be used to blow off any excess that has pooled. Let dry for 5 minutes.Repeat above 1 – 2 more times and let final coat dry for at least 1 hour.If recommended by mold rubber manufacturer, apply a light mist coating of release agent (i.e. Ease Release® 200). Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.Important: Discoloration of model surface may occur. If compatibility between SuperSeal® and model surface or SuperSeal® and a particular mold rubber is a concern, a small-scale test should be made on an identical surface prior to use.
